- All Products
- Shop by Brands
- BW Technologies
- BW Technologies
- BW Technologies Monitors
- Models
- BW Clip
- BW Clip4
- GasAlertClip Extreme
- GasAlert Extreme
- GasAlertMicroClip XT
- GasAlertMicroClip XL
- GasAlertMicroClip X3
- GasAlertQuattro
- GasAlertMax XT II
- GasAlertMicro 5 Series
- SamplerPak
- IntelliDox Docking System
- MicroDock II
- BW Ultra
- BW Solo
- Gas Monitors
- Gas Monitor Manufacturers
- BW Technologies
- Bacharach
- Biosystems
- Crowcon
- Gas Clip Technologies
- GfG Instruments
- GMI/Detcon
- Honeywell Analytics
- Industrial Scientific
- MSA
- RAE Instruments
- RKI Instruments
- Calibration Gas
- Combustion Analyzers
- Water Quality
- Reliability Instruments
- Refractometers
- HVAC
- Weather
- Temperature
- Laboratory
- Sound
- IAQ
- Electrical
- All Categories
Extech CT20 Remote & Local Continuity Tester
Item #:
EXT-CT20
Brand:
Extech
Share this product:
CT20 Remote & Local Continuity Tester by Extech
Features
- A bright flashing LED and loud pulsating beeper indicate local continuity
- Remote continuity - with the use of the remote probe, it does not tie-up two people when identifying and labeling long distance wire/cable runs
- Flashing remote probe - Two lead, bi-color (red/green) LED probe allows a single user to identify up to three wires or cables at a time for correct labeling with only one trip to the other end location - cuts down on multiple trips back and forth
- Polarity verification - Drives a 20mA DC current pulse through the wires or cables under test to the bi-color remote probe; This enables the technician to identify each of the wires under test at the other end of the cable run and eliminates the possibility of false high impedance readings
- Lightweight/Pocketsize - clips on and hangs from the cable(s) under test without falling off
- Dims: 3.6x2.2x1.14" (90x57x29mm); Wt: 9.2oz (260g)
- Complete with remote probe, test leads with alligator clips, 9V battery and pouch
Power supply | 9 Volt Battery |
Beeper | 85dB beeper |
Battery life | Approx. 12 months with normal use. |
Continuity confirmation | Equal to or less than 2.0 K Ohms |
Continuity drive current | Pulsed (2.0 Hz) 20 - 50mA at 10 Ohms and 2.0mA - 8.0mA at 1000 Ohms. |
Wire Verification Distance | 10,000 Ft, 3,000 m (26 Gage min.) |
Fuse | 250V 0.5A fast blow |
Operating Temperature | 10°F to 113°F (-12 to 45°C) |
Storage Temperature | -4 to 176°F (-20 to 80°C) |
Operating Humidity | 10 to 90% RH (non-condensing) |
Dimensions | 3.6 x 2.2 x 1.14" (90 x 57 x 29mm) |
Weight | 9.2oz (260g) |