- All Products
- Shop by Brands
- BW Technologies
- BW Technologies
- BW Technologies Monitors
- Models
- BW Clip
- BW Clip4
- GasAlertClip Extreme
- GasAlert Extreme
- GasAlertMicroClip XT
- GasAlertMicroClip XL
- GasAlertMicroClip X3
- GasAlertQuattro
- GasAlertMax XT II
- GasAlertMicro 5 Series
- SamplerPak
- IntelliDox Docking System
- MicroDock II
- BW Ultra
- BW Solo
- Gas Monitors
- Gas Monitor Manufacturers
- BW Technologies
- Bacharach
- Biosystems
- Crowcon
- Gas Clip Technologies
- GfG Instruments
- GMI/Detcon
- Honeywell Analytics
- Industrial Scientific
- MSA
- RAE Instruments
- RKI Instruments
- Calibration Gas
- Combustion Analyzers
- Water Quality
- Reliability Instruments
- Refractometers
- HVAC
- Weather
- Temperature
- Laboratory
- Sound
- IAQ
- Electrical
- All Categories
Bacharach 6401-0501 MGS-250 Infrared R22 Detector
Item #:
6401-0501
Brand:
Bacharach
Share this product:
6401-0501 MGS-250 Infrared R22 Detector by Bacharach
Bacharach's new MGS-250 Infrared Refrigerant Gas Transmitter is the leader in performance and flexibility at an economical price. There are two versions available - a cost-effective broadband sensor used for gross leak detection or gas-particular versions that are even more distinct, pre-calibrated and characterized for response to specific refrigerants. Its simple-to-use interface gives the user the ability to set all parameters and outputs without opening the unit, moving jumpers, using mulitmeters or adjusting potentiometers.
The MGS-250 family is a cost effective solution for detecting a variety of refrigerants without the limitations posed by solid-state sensor technologies. The long-life, proprietary NDIR infrared sensor allows for accurate low-level leak detection (0-3,500 ppm), delivering up to 5-7 years of maintenance-free operation without the need for costly annual gas calibrations. Infrared sensing technology makes the MGS-250 immune to cross sensitivities to combustible and toxic gas as well as changes in temperature and humidity. The unit has an alpha-numeric LED display to show constant real-time readings, an on-board LED indicator for when the sensor is in an alarm state, and an audible alarm to alert personnel in the area that levels have exceeded the desired limit. An optional protective splash guard is available for use in areas with high water spray such as food and beverage facilities or chiller rooms.
Features & Benefits:
- Long-life, Non-Dispersive Infrared (NDIR) sensor allows for accurate low-level leak detection
- Detects all refrigerants (CFC, HFCs, HCFC, HFO's), including HFO1234YF, HFO1234ZE, R410a & R22
- Fast-responding, refrigerant-specific sensor with no cross interferences to other gases
- No field calibrations required
- Modbus RTU interface to connect to BAS/BMS systems and on-board alarm relay
- User selectable analog output: 4-20 mA, 0-5V, 1-5V, 0-10V, 2-10V
- Bright, alpha-numeric LED real-time display with on-board audible and visual alarms
Power Supply | 24 VDC @ 0.15 A min; 24 VAC, 5 VA min @ 50/60 Hz, 2.5 W max |
Power Monitoring | Green LED |
Visual Alarm | Red 4-digit LED display |
Audible Alarm | Buzzer (audible alarm), enable/disable |
Fault Monitoring | Fault codes presented to user |
Analog Outputs | 4-20 mA; 0-5 V; 0-10 V; 1-5 V; 2-10 V |
Relay | 1 relay rated 1 A @ 24 VAC/VDC (0.5A, 125V AC UL rating) |
Range | 0-3500 ppm |
Squelch1 | Readings below 75 ppm are squelched by default |
Communication: Modbus RTU over RS-485 | Baud rate: 9,600 or 19,200 (selectable) Start bits: 1; Data bits: 8 Parity: None, odd, even (programmable) Stop bits: 1 or 2, programmable Retry time: 500 ms (min time between retries) End of msg: Silent 3.5 characters |
Alarm Delay | Selectable; 0 to 15 minutes |
IP Rating | Not IP rated. An accessory splash shield is available for areas requiring additional protection from wash down. |
Response Time | T90 < 5 minutes |
Temperature Rating | -22° to 104° F (-30° to 40° C) |
Humidity and Elevation | 5-90% relative humidity, non-condensing, 0-10,000 ft. altitude |
Weights/Dimensions | 6.3 oz, 4.0" x 5.5" x 1.5" (180 g, 102 x 140 x 37 mm) |
Enclosure | ABS plastic; UL flammability rating of 94V-0 |
Approvals | CE, UL/CSA/IEC/EN 61010-1 |