- All Products
- Shop by Brands
- BW Technologies
- BW Technologies
- BW Technologies Monitors
- Models
- BW Clip
- BW Clip4
- GasAlertClip Extreme
- GasAlert Extreme
- GasAlertMicroClip XT
- GasAlertMicroClip XL
- GasAlertMicroClip X3
- GasAlertQuattro
- GasAlertMax XT II
- GasAlertMicro 5 Series
- SamplerPak
- IntelliDox Docking System
- MicroDock II
- BW Ultra
- BW Solo
- Gas Monitors
- Gas Monitor Manufacturers
- BW Technologies
- Bacharach
- Biosystems
- Crowcon
- Gas Clip Technologies
- GfG Instruments
- GMI/Detcon
- Honeywell Analytics
- Industrial Scientific
- MSA
- RAE Instruments
- RKI Instruments
- Calibration Gas
- Combustion Analyzers
- Water Quality
- Reliability Instruments
- Refractometers
- HVAC
- Weather
- Temperature
- Laboratory
- Sound
- IAQ
- Electrical
- All Categories
GfG EC 28i Intrinsically Safe Transmitter with Carbon Monoxide (CO) Sensor, 1 ppm Resolution, 0 - 1,000 ppm Range, Display - 2813-428-002
Item #:
2813-428-002
Brand:
GfG
Share this product:
2813-428-002 EC 28i Intrinsically Safe Transmitter with Carbon Monoxide (CO) Sensor, 1 ppm Resolution, 0 - 1,000 ppm Range, Display by GfG
Wherever hazards are expected, the EC 28 transmitter and GfG's proven monitoring systems are the right choice for reliable surveillance. The ATEX-certified Ex-proof design, and bright alarm LEDs provide the highest safety in hazardous areas. The gas alarm not only alerts the person in the control room of hazards, but also the person on-site.
Smart sensor technology allows a user to install the transmitter or to replace a sensor within a few seconds - just plug the sensor into the transmitter. Adjustments are done directly at the transmitter using touch keys or with the RC2 remote control (one-person calibration).
Accurate sensors and integrated temperature compensation provide the highest measurement accuracy. Low maintenance requirements and the long sensor life reduce your cost of ownership.
Features
- Increased safety design to reduce installation cost in potentially hazardous locations
- Non-intrusive AutoCal® calbiration adjustment
- Uses electrochemical detection principle
- Output signal: 4-20 mA
- Intrinsically safe (i) EX-Proof
- Available in two configurations: Blind (no display); Display
- Barriers are required
- EX- conduit is not required