Set up Reverse Intelliflash

Set up Reverse IntelliFlash

IntelliFlash flashes a green light when the detector is in compliance, but Reverse IntelliFlash^® flashes an amber light when the detector is not in compliance (a bump test or calibration is overdue, or a sensor is not working and has been overridden). Use Fleet Manager II to change how often the detector flashes for Reverse IntelliFlash. IntelliFlash and Reverse IntelliFlash can be configured in one of four scenarios:

Scenario 1

When both IntelliFlash and Reverse IntelliFlash are enabled, the detector’s green LED will flash until it goes out of compliance, then its amber LED will flash instead.

Scenario 2

If IntelliFlash is enabled and Reverse IntelliFlash is disabled, the detector’s green LED flashes until it goes out of compliance, then it stops flashing.

Scenario 3

If IntelliFlash is disabled and Reverse IntelliFlash is enabled, neither LED will flash while the detector is in compliance. The amber LED will flash if it goes out of compliance.

Scenario 4

When both IntelliFlash and Reverse IntelliFlash are disabled, neither LED will flash under any circumstances.