Transfer Datalogs from a Detector

There are two ways to transfer datalogs from a detector to the module:
1. Manually, via the module operations menu, or
2. Automatically, by configuring detector settings via Fleet Manager II software.

Transferring Datalogs via the Detector Operations Menu

1. Insert a compatible detector into the module. Detector identification is displayed on the LCD. After the detector is recognized, procedures specified to occur automatically on insertion are performed.
2. When the module is configured to transfer datalogs on insertion, the datalogs are transferred after other procedures specified to occur automatically on insertion are completed. Go to step 5.
3. When the module is NOT configured to transfer datalogs on insertion, What do you need to do? is displayed after the detector is recognized. Go to step 4.
4. Pressorto select Transfer datalogs from my detector, and then press. If the procedure is passcode-protected, then enter the passcode and pressto continue. The LCD changes to yellow. A progress bar and the Datalog file transfer message are displayed.
5. When the transfer is complete, the LCD changes to green and Datalog transfer complete is displayed. Pressto continue.
6. Open the lid and remove the detector, or perform other procedures.

Transferring Datalogs Automatically by Configuring Settings via Fleet Manager II Softwar

For more information about creating and transferring configuration settings files via Fleet Manager II software, refer to Configure Module and Detector Settingson page 58. For more information about configuring settings via Fleet Manager II software, refer to the Fleet Manager II operator manual.