1-866-4 JJSTECH(1-866-455-7832)

  1. Home
  2. BW Clip4 maintenance

BW Clip4 maintenance

Cleaning the Detector

Clean the detector using a soft cloth with water-based or non-alcoholic cleaner. Other types of cleaners, solvents and lubricants can contaminate and cause permanent damage to the detector sensors.

Replacing the Belt Clip

Cleaning the Detector

If the belt clip is damaged or loose, replace it with a new one. Insert a screwdriver through the hole in the clamp and loosen the screw to detach the clip. Put a new clip in place and fasten it.

Replacing the Sensor Filter

If the sensor filter is dirty or damaged, please replace it with a new one.

Cleaning the Detector

1. Loosen the six screws on the back of the detector to separate the front panel.

Cleaning the Detector

2. Loosen the two screws on the PCB to remove it from the front panel.

Cleaning the Detector

3. Remove the sensor filter from the inside of the front panel.

4.Put a new filter in place

5. Reassemble the detector in the reverse order.

CAUTION

Improper re-assembly of the BW Clip4 detector could lead to damage and loss of ingress protection.