- All Products
- Shop by Brands
- BW Technologies
- BW Technologies
- BW Technologies Monitors
- Models
- BW Clip
- BW Clip4
- GasAlertClip Extreme
- GasAlert Extreme
- GasAlertMicroClip XT
- GasAlertMicroClip XL
- GasAlertMicroClip X3
- GasAlertQuattro
- GasAlertMax XT II
- GasAlertMicro 5 Series
- SamplerPak
- IntelliDox Docking System
- MicroDock II
- BW Ultra
- BW Solo
- Gas Monitors
- Gas Monitor Manufacturers
- BW Technologies
- Bacharach
- Biosystems
- Crowcon
- Gas Clip Technologies
- GfG Instruments
- GMI/Detcon
- Honeywell Analytics
- Industrial Scientific
- MSA
- RAE Instruments
- RKI Instruments
- Calibration Gas
- Combustion Analyzers
- Water Quality
- Reliability Instruments
- Refractometers
- HVAC
- Weather
- Temperature
- Laboratory
- Sound
- IAQ
- Electrical
- All Categories
Kanomax 2000 to 12500 FPM (0 to 10.0 in. wg) Magnehelic®Gauge for Air Velocity/Dual Scale - 2010AV
Item #:
2010AV
Brand:
Kanomax
Share this product:
Magnehelic® Gauges
The Magnehelic® is ideal for measuring air velocity, fan & blower pressures, filter resistance, furnace draft, pressure drop across orifice plates. Guaranteed within 2% of full scale and a wide choice of models available the Magnehelic® has been used successfully on a wide range of applications.
Model | Minihelic® II |
Service | Air and non-combustible. (Natural Gas option available) |
Wetted Materials | Consult Factory |
Housing | Die cast aluminum case and bezel, with acrylic cover. Exterior finish is coated gray to withstand 168 hour salt spray corrosion test. |
Accuracy | ±5% of full scale at 70°F (21.1°C) |
Pressure Limits | 20 Hg. to 15 psig.*(-0.677 bar to 1.034 bar); MP option 35 psig (2.41 bar), HP option 80 psig (5.52 bar). |
Overpressure | Relief plug opens at approximately 25 psig (1.72 kPa), standard gauges only |
Temp Limits | 20 to 140°F (-6.67 to 60°C) |
Size | 4” (101.6mm) Diameter dial face |
Mounting Orientation | Diaphragm in vertical position. Consult factory for other position orientations |
Process Connections | 1/8” female NPT duplicate high and low pressure taps one pair side and one pair back |
Weight | 1 lb. 2 oz (510g), MP & HP 2 lb 2 oz (963 g) |
Standard Accessories | Two 1/8” NPT plugs for duplicate high and low pressure taps, two 1/8” pipe
thread to rubber tubing adapter and three flush mounting adapters with screws. (Mounting and snap ring retainer substituted for 3 adapters in MP & HP gage accessories) |