- All Products
- Shop by Brands
- BW Technologies
- BW Technologies
- BW Technologies Monitors
- Models
- BW Clip
- BW Clip4
- GasAlertClip Extreme
- GasAlert Extreme
- GasAlertMicroClip XT
- GasAlertMicroClip XL
- GasAlertMicroClip X3
- GasAlertQuattro
- GasAlertMax XT II
- GasAlertMicro 5 Series
- SamplerPak
- IntelliDox Docking System
- MicroDock II
- BW Ultra
- BW Solo
- Gas Monitors
- Gas Monitor Manufacturers
- BW Technologies
- Bacharach
- Biosystems
- Crowcon
- Gas Clip Technologies
- GfG Instruments
- GMI/Detcon
- Honeywell Analytics
- Industrial Scientific
- MSA
- RAE Instruments
- RKI Instruments
- Calibration Gas
- Combustion Analyzers
- Water Quality
- Reliability Instruments
- Refractometers
- HVAC
- Weather
- Temperature
- Laboratory
- Sound
- IAQ
- Electrical
- All Categories
RKI Instruments SP-205ASC Portable Leak Checker for Phosphine (PH3)(Also Detects Arsine, Diborane, Silane, & Hydrogen)
Item #:
72-0066RK
Brand:
RKI Instruments
Share this product:
72-0066RK Portable Leak Checker for Phosphine (PH3)(Also Detects Arsine, Diborane, Silane, & Hydrogen) by RKI Instruments
The truly portable and personal leak tester model SP0205ASC can be conveniently over the shoulder with its carrying strap These units automatically draw leaking gases with each internal pump When an optional earphone is used alarm buzzer sound can be heard in spite of a hard back-ground noise. With model SP205ASC, workers can now be individually protected from potentially dangerous toxic gas leaks. These units are also used as leak checkers at pipe, pump connections. It can give an early warning indication of small leaks before they become large and potentially dangerous.
An intermittent tone sounds and an LED lamp flashes if a gas leak is detected. The tone frequency is proportional to the gas concentration, i.e., low gas concentration is signalled by a slow beep and higher gas concentration by a faster beep.
The model SP-205ASC is specially designed for the use of semiconductor industry and to detect the presence of special gas such as gaseous hydride at much higher sensitive level. Low battery alarm and gas alarm lamp are provided. After power on and turning gas selection switch to either side, find an alarm end point by turning alarm set wheel. This is ready to run. When it is necessary to have a gas concentration, turn the alarm setting wheel counterclockwise for additional graduations in clean air after the prior alarm wheel setting. Model SP-205ASC can show you an approximate gas concentration according to tables shown below.
Features
- Lightweight, compact, easy to use
- LED lamp flash, intermittent buzzer for a warning
- Intrinsically safe design
- Lamp goes off for low battery voltage
- Sample draw system
- Fast response and high sensitivity
*Please note we can only ship RKI products to customers within the United States
Model | SP-205ASC | ||||
Detection Principle | Catalytic/semiconductor combination. Sample-drawing with special built-in diaphragm pump | ||||
Gases detected | Phosphine (PH3) |
Arsine (AsH3) |
Diborane (B2H6) |
Silane (SiH4) |
Hydrogen (H2) |
Detectable leak amounts (atm • cc/sec) |
1.5x10-6 | 1.0x10-6 | 0.5x10-6 | 2.5x10-6 | 5.0x10-6 |
Detectable concentration | 0.3 ppm | 0.2 ppm | 0.1 ppm | 0.5 ppm | 1.0 ppm |
Response time | Within ten (10) minutes | ||||
Alarm indication | Intermittent buzzer and LED lamp | ||||
Power source | Size "AA" Alkaline battery cells x 4 pcs Continuous operating time approx. 7 hours at 20 °C Automatic voltage drop indication |
||||
Operating temperature | 0°C ~ + 40°C | ||||
Outer dimensions & Weight | 68(W) x 155(H) x 32(D) mm, Approx. 400g 2.7(W) x 6.1(H) x 1.3(D)inch, Approx. 0.9lb |
||||
Accessories | Carrying case, check gas, filter unit, filter, batteries, taper nozzle | ||||
Optional Accessories | Earphone, long taper nozzle |